The waterjet cuts with a circular jet of water, therefore any internal corner can only be cut with a...
Read More
Standard sheet sizes for metal are usually as follows: 1 x 2, 1.25 x 2.5, 1.5 x 3, 2 x 4, 3 x 6 (in...
Cut profiles only need to be separated by a small amount - we usually leave 3.5mm. We will usually n...
These are profiles where there is a large density of holes / cut outs (see diagram 3 & 4). The cost ...
It follows from the above point that your smallest hole size is also dictated by the jet size. Holes...
Waterjets cutting hard materials (metals/hard plastics etc) use an abrasive jet (a beam of water whi...
Can you cut tube / box section with a waterjet? A. Yes….BUT….the waterjet will cut one wall of the ...
Toughened or tempered glass is a type of safety glass processed by controlled thermal or chemical tr...